Tankless electric water heater
instant electric water heaters
home /

instant electric water heaters

/

Small Apartment Water Heater: A Layout and Buying Guide

Small Apartment Water Heater: A Layout and Buying Guide

18 Nov 2026

In a small flat, a water heater is not a purchase. It is a placement decision.

A studio or a one-bedroom flat has three or four outlets and one narrow wall where a unit can live. Choose the wall first and the model second, and most of the hard questions answer themselves. Choose the model first and you spend the next five years looking at a cable run that should have decided the layout.

Anlabeier, the instant electric water heater brand of Zhongshan Chongde Electric Co., Ltd., builds units from 3.5 kW to 12 kW, which is the range small flats actually use: a point-of-use unit at one outlet, or one unit feeding two.

Start With the Outlets, Not the Product

  • Write down every place that needs hot water: shower, basin, kitchen sink, washing machine. Four is common in a small flat.
  • Mark which two might run at the same time. In a one-bathroom flat it is usually the shower and the kitchen sink, not two showers.
  • Measure the pipe run from each possible unit position to each outlet. Long runs waste water before hot arrives and lose temperature on the way.
  • Note what is on the other side of each wall: a cupboard, a corridor, a neighbour. That decides whether a unit can be recessed or only surface-mounted.

Recommendation: sketch the flat on one page and mark the outlets before you open a product page.

One Unit for the Flat, or One Per Outlet

  • A single unit of 6–8 kW at the bathroom wall covers a shower and a basin comfortably, if the circuit can carry it and the kitchen is close enough.
  • Two smaller units — one at the bathroom, one at the kitchen — split the electrical load and shorten every run, at the cost of two units to buy, mount and maintain.
  • In a flat where the kitchen sits at the far end of a corridor, a second small unit often beats a long pipe run.

The Circuit Budget Comes First

  • A 3.5 kW unit draws about 15 A at 230 V. A 6 kW unit needs roughly 26 A, and 12 kW needs a supply most small flats do not have.
  • Many apartment blocks have a consumer unit with no spare way, and the shower circuit is already the heaviest one.
  • Ask an electrician what the existing supply can take before you shortlist anything; the answer may remove half the catalogue.
  • Never move or extend a heater circuit yourself. Use a licensed electrician and keep the certificate with the flat's paperwork.

Recommendation: price the circuit work before the unit. In a small flat the wiring is the real budget line.

Where the Unit Can Physically Go

  • Wall space above or beside a basin is usually the only free surface, so check the unit's dimensions against the tiles before ordering.
  • A unit inside a cupboard stays tidy but needs ventilation and room for service; a sealed box with no access turns a repair into a demolition.
  • Bathroom wet zones have rules about what can be mounted where; they vary by market, so check the local requirement rather than assuming.

Point of Use Water Heater: Where It Wins in a Small Flat

  • Point-of-use means the unit sits at the outlet, so the wait for hot water is short and the pipe run is negligible.
  • It suits a flat where the bathroom and the kitchen are far apart, or where the supply cannot carry one large unit.
  • A single Anlabeier unit costs more per outlet than one shared model, and each unit needs its own connection point and its own maintenance.
  • Kitchen use is usually a light duty — handwashing and dishes — so a small unit is enough; the details are in Under Sink Water Heater: What to Check Before You Buy.

Recommendation: pay for point-of-use where the run is long or the circuit is weak, and not for the whole flat by default.

Anlabeier wall-mounted instant water heater beside a shower in a small bathroom, serving one outlet on a short pipe run

A Buying Checklist for Small Units

  • Rated power in kW, matched to the circuit rather than to the brochure.
  • Stainless steel or cast aluminium heating element, chosen for the local water hardness.
  • IPX4 casing, ELCB leakage protection, dry-heating cutoff and overheat protection.
  • Physical dimensions, including clearance for the hoses below the unit.
  • Warranty terms, spare-parts availability and a model that will still exist in five years.

Pressure, Flow and the Cold Morning

  • Small flats often have modest water pressure; a unit rated for a higher flow will simply deliver a lower temperature rise if the flow is not there.
  • Cold inlet water in winter reduces the temperature rise at any given flow, so a unit sized in summer can feel weak in January — the checks are in Tankless Water Heater in Winter: 5 Checks for Cold Days.
  • Two outlets open at once split the unit's output; if that is a daily habit, size for it or add a second unit.

Renters and Small Flats

  • A tenant can usually change a shower head, not a circuit. Anything that touches wiring needs the owner's written agreement.
  • If the flat already has a suitable circuit, a like-for-like swap is the least disruptive option; the failure model is set out in Water Heater for Rental Property: A Landlord's Buying Guide.
  • Keep the old unit's model number. It is the fastest way to confirm what the existing circuit was built for.

Why Anlabeier

Anlabeier is the instant electric water heater brand of Zhongshan Chongde Electric Co., Ltd., a manufacturer in Zhongshan, Guangdong that has built instant electric water heaters since 2010. The 3.5 kW point-of-use models are sized for exactly this problem: one outlet, one short run, one narrow wall. The range runs to 12 kW for whole-flat use, with stainless steel or cast aluminium elements, ELCB leakage protection, dry-heating cutoff, overheat protection and IPX4 casings. The company holds more than 120 patents, works to CE, CB, RoHS, ETL and ISO9001 standards, and tests units at incoming inspection, temperature-control, semi-finished, finished-product and packaging stages.

Zhongshan Chongde Electric Co., Ltd. (Anlabeier) production equipment, including water-pump testing, a vibration test bench and finished-product testing stations

Conclusion

Small-flat hot water is a drawing exercise before it is a purchase. Count outlets, mark the simultaneous pair, ask what the circuit can carry, then choose one unit or two. Anlabeier units from Zhongshan Chongde Electric Co., Ltd. start at 3.5 kW precisely because the smallest flats are where placement, not power, decides the result.

FAQ

Can a small apartment have a tankless water heater?
Yes, and small flats are often the easiest case: one or two outlets, short runs, and a unit that hangs on the wall instead of taking a cupboard. The limit is the supply, not the floor area.

How many kW does a small flat need?
A single shower outlet is usually served by 3.5 kW; a unit feeding a shower and a basin is typically 6–8 kW. The figure has to match the circuit, which is why the electrician's answer comes before the model number.

Is one unit or two better in a studio?
If the kitchenette and bathroom are metres apart, one unit is simpler. If they sit at opposite ends of the flat, two small units usually beat one long pipe run. Which type suits the building is covered in Tankless vs Tank Water Heater: Which One Fits Your Home.

leave a message Leave a message
24 hour online service, welcome to contact us for more information at anytime!